Juniper-networks ERX-1410 Manual do Utilizador descarregar pdf (Página 96)

CHAPTER 7

Maintaining the ERX System

7-4

6 When this SRP module is available, synchronize the SRP modules.

host1#synchronize

7 When the SRP modules are synchronized, reboot the SRP module

that you upgraded.

host1#reload slot 6

8 When this SRP module is available, synchronize the SRP modules.

host1#synchronize

9 When the SRP modules are synchronized, force the redundant SRP

module to take over from the primary SRP module.

host1#srp switch

10 Immediately remove the former primary SRP module.

11 Repeat steps 4–8 for the former primary SRP module.

Replacing an NVS Card

To replace an NVS card on an SRP module:

1 Obtain an antistatic container for the NVS card you will remove (see

Storing Modules and Components, earlier in this chapter).

2 With a small flathead screwdriver, remove the faceplate from the

NVS card slot on the SRP module (see Figure 7-1).

3 Use the screwdriver to depress the button next to the NVS card (see

Figure 7-1).

This action releases the NVS card.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 183 184

Sem comentários

Juniper-networks ERX-1410 Manual do Utilizador Página 96