Juniper Networks IDP250 Manual do Utilizador descarregar pdf (Página 45)

Getting Started with the EasyConfig Wizard (Serial Console Port)

We recommend you get started by running the EasyConfig wizard to assign an IP

address to the management interface. Then, you can access the ACM Wizard from

a remote location to complete the appliance configuration.

To perform the initial configuration with the EasyConfig wizard:

1. Connect one end of the provided RJ-45 null modem serial cable to the serial

console port located on the front of the appliance chassis.

2. Connect the other end of the cable to the serial port of your laptop.

3. Open a terminal emulation package such as Microsoft Windows HyperTerminal

or XModem. The settings for the software should be as follows:

■ 9600 bps

■ 8 data bits

■ No parity generation or checking

■ 1 stop bit

■ No flow control

■ The serial port number where you connected the cable

4. Turn on the appliance.

If nothing appears in the terminal window, press Enter to display the boot

messages.

5. Log into the appliance as root with the default password (abc123).

NOTE: After you have completed the initial configuration, we highly recommend

that you use ACM to change the default password.

The EasyConfig script runs automatically. The following text appears:

Configuring the deployment mode...

The currently supported deployment modes in EasyConfig are the following,

1. Sniffer <default>

2. Inline transparent

Choose the deployment mode? [1]

6. Press 1 or 2 and press Enter.

The following text appears:

Configuring Management interface...

The management interface is currently configured as:

IP: 192.168.1.1

Getting Started with the EasyConfig Wizard (Serial Console Port) ■ 29

Chapter 5: Performing the Initial Network Configuration and Licensing Tasks

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 83 84

Sem comentários

Juniper Networks IDP250 Manual do Utilizador Página 45