Juniper-networks Juniper M-series M10i Manual do Utilizador descarregar pdf (Página 72)

SONET/SDH OC48c/STM16 PIC with SFP

■

JUNOS 6.4 and laterSoftware release

■

One OC48 port

■

Power requirement: 0.86 A @ 48 V (41.4 W)

Description

■

Multiplexing and demultiplexing on the 1-port PIC

■

Rate policing on input

■

Rate shaping on output

■

Packet buffering, Layer 2 parsing

Hardware features

■

Optical diagnostics and related alarms

■

SONET/SDH framing

■

Link aggregation

■

Alarm and event counting and detection

■

Dual-router automatic protection switching (APS)

■

Multiprotocol Label Switching (MPLS) fast reroute

■

Encapsulations:

■

High-Level Data Link Control (HDLC)

■

Frame Relay

■

Circuit cross-connect (CCC)

■

Translational cross-connect (TCC)

■

Point-to-Point Protocol (PPP)

Software features

You can install any transceiver supported by the PIC. For information about installing and

removing transceivers, see the PIC and Transceiver Installation Instructions.

■

Duplex LC/PC connector (Rx and Tx)

■

Optical interface support—See Table 20 on page 74

NOTE: To extend the life of the laser, when a PIC is not being actively used with any valid

links, take the PIC offline until you are ready to establish a link to another device. For

information about taking a PIC offline, see the request chassis pic offline command in the

JUNOS System Basics and Services Command Reference.

Cables and connectors

72 ■ SONET/SDH OC48c/STM16 PIC with SFP

M10i Internet Router PIC Guide

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 78

Comentários a estes Manuais

Sem comentários

Juniper-networks Juniper M-series M10i Manual do Utilizador Página 72

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Juniper-networks Juniper M-series M10i