Juniper-networks J-series Services Router J2320 Manual do Utilizador descarregar pdf (Página 150)

100

101

overtighten. Apply between 8 lb-in. (0.9 Nm) and 9 lb-in. (1.02 Nm) of torque

to the screw.

f. Using the other removed screw, secure the negative (–) DC source power

cable lug to the –48 VDC terminal. Tighten the screw until snug. Do not

overtighten. Apply between 8 lb-in. (0.9 Nm) and 9 lb-in. (1.02 Nm) of torque

to the screw.

g. Dress the power cables appropriately.

h. Replace the clear plastic cover over the terminal block.

4. Verify that the power cables do not block access to router components or drape

where people can trip on them.

5. On J2320 and J2350 routers, use the power cable tie as follows to relieve strain

on the cable (see Figure 65 on page 128 ):

a. Wrap the loose end of the tie around the cable, and insert it into the opening

on the tie.

b. Pull the end to tighten the tie.

To release the tie from the cable, press down the tab on the tie and loosen it.

Figure 65: Connecting DC Power to the J2350 Services Router

128 ■ Connecting Power

J2320, J2350, J4350, and J6350 Services Router Getting Started Guide

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 331 332

Comentários a estes Manuais

Sem comentários

Juniper-networks J-series Services Router J2320 Manual do Utilizador Página 150

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Juniper-networks J-series Services Router J2320